Cisco ASR 9000 Series - Page 1128

DescriptionField
Displays the following line alarms:
• AIS—Number of AIS errors on this line. AIS
alarms are critical because they indicate that the
line is down.
• RDI—Remote defect indication.
◦
Line remote defect indication is reported
by the downstream LTE when it detects
LOF4, LOS5, or AIS6.
◦
Path remote defect indication is reported
by the downstream PTE when it detects a
defect on the incoming signal.
• FEBE—Number of far-end block errors (FEBE)
on this line. Line FEBE errors are accumulated
from the M0 or M1 byte, and are reported when
the downstream LTE detects BIP7 (B2) errors.
• BIP(B2)—Number of bit interleaved parity
(BIP) B2 errors on this line that exceeded the
specified threshold.
LINE
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1108
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
show controllers wanphy