DescriptionField
Displays the following path alarms:
• AIS—Number of AIS errors on this path. AIS
alarms are critical because they indicate that the
line associated with this path is down.
• RDI—Number of RDI errors on this path. Path
RDI is a legacy alarm and is not supported.
• FEBE—Number of FEBE errors on this path.
Path FEBEs are accumulated from the G1 byte,
and are reported when the downstream PTE
detects BIP (B3) errors.
• BIP(B2)—Number of bit interleaved parity
(BIP) errors on this path that exceeded the
specified threshold.
• LOP—Number of loss of pointer (LOP) errors
on this path. Path LOPs are reported as a result
of an invalid pointer (H1, H2) or an excess
number of new data flag enabled indications.
• NEWPTR—Inexact count of the number of
times the SONET framer has validated a new
SONET pointer value (H1, H2).
• PSE—Inexact count of the number of times the
SONET framer has detected a positive stuff
event (PSE) in the received pointer (H1, H2).
• NSE—Inexact count of the number of times the
SONET framer has detected a negative stuff
event in the received pointer (H1, H2).
For Cisco IOS XR software release 3.5.0,
the following fields display no
errors:RDIFEBEBIP(B2)NEWPTRPSENSE
Note
PATH
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1109
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
show controllers wanphy
To Next Page
Loading...
