DescriptionField
Displays the following WAN Interconnect Sublayer
(WIS) layer alarms:
• SER—Number of Severely Errored Frames
(SER) errors
• FELCDP—Number of Far End - Loss of
Code-group Delineation - Path (FELCDP) errors
• FEAISP—Number of Far End - AIS - Path
(FEAISP) errors
• WLOS—Number of WIS LOS (WLOS) errors.
• PLCD—Number of Path Loss of Code-group
Delineation (PLCD) errors
• LFEBIP—Number of Line - Far End - BIP
(LFEBI) errors
• PBEC—Number of Path - Block Error Counter
(PBEC) errors
Alarms are applicable only when the
controller is configured in WAN-PHY mode.
Note
WIS ALARMS
Total number of currently active alarms on this
interface.
Alarms are applicable only when the
controller is configured in WAN-PHY mode.
Note
Active Alarms[All defects]
Total number of the most significant active alarms
on this interface. These alarms are likely causing all
other alarms on the interface.
Alarms are applicable only when the
controller is configured in WAN-PHY mode.
Note
Active Alarms[Highest Alarms]
Total number of errored K1/K2 bytes from the Line
OverHead (LOH) of the SONET frame that were
received by this interface.
Rx(K1/K2)
Total number of errored K1/K2 bytes from the Line
OverHead (LOH) of the SONET frame that were
transmitted by this interface.
Tx(K1/K2)
Number of errored payload pointer bytes on this
interface.
S1S0
Number of errored STS identifier (C1) bytes on this
interface.
C2
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1110
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
show controllers wanphy
To Next Page
Loading...
