EasyManuals Logo

MCE iControl User Manual

Default Icon
806 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #785 background imageLoading...
Page #785 background image
Index-3
voltage, on Operational Status tab 9-9
voltages 9-26, 9-28
wiring 2-23
Brake adjustments to control rollback (System 12) 2-57
Brake calibration (Quattro DC) 2-77–2-80
Brake calibration (System 12) 2-57–2-60
BRAKE CNT DRV PRF FLT message 6-14
BRAKE CONT PRF FAULT message 6-14
Brake Contactor Driver Proofing Fault message 6-14
Brake Contactor Proofing Fault message 6-14
Brake Contactor Status test point, description 11-4
Brake coordination, adjusting for smooth stops 4-33
Brake Current Feedback test point, description 11-4
Brake current low pass frequency parameter 9-26
Brake Current Resistance 2-22
Brake Current Signal test point, description 11-4
Brake Drive Redundancy indicator 11-12
Brake drop delay 9-27
Brake drop delay, adjusting for final stop 4-31
BRAKE DROP FAULT message 6-15
Brake Drop Fault message 6-15
Brake Enable Fault message 6-15
Brake Enable Status test point, description 11-4
Brake Holding Voltage output 9-145
Brake IGBT Fault, see Excessive Brake Feedback Fault 6-34
Brake Module Over Temperature Fault message 6-15
Brake Output Circuit Failure message 6-15
BRAKE OUTPUT FAILURE message 6-15
BRAKE OVER TEMP FAULT message 6-15
Brake pick delay 9-27
adjusting 3-31
BRAKE PICK FAULT message 6-16
Brake picking, adjusting (Quattro DC) 2-80
Brake Switch 3-20
Brake Switch input 3-20, 9-134
Brake Triac active indicator 11-12
BRAKE V NOT OFF FAULT message 6-16
BRAKE V NOT ON FAULT message 6-16
Brake Voltage Feedback test point, description 11-4
Brake voltage low pass frequency parameter 9-26
Brake Voltage Not Off Fault message 6-16
Brake Voltage Not On Fault message 6-16
Brake Voltage Signal test point, description 11-4
BRD, Brake Redundancy indicator 11-12
Bus 2 Fuse Open message 6-16
Bus 2D Fuse Open message 6-16
Bus 2MC Fuse Open message 6-16
Bus 2PI Fuse Open message 6-16
Bus 3 Fuse Open message 6-17
Bus 3HA Fuse Open message 6-17
Bus Enabled 5-26
Bus Status 5-26
Bus Voltage 5-26
Button Bar 8-18
Bypass Jumper, using for troubleshooting 6-3
Bypass status, Fault bypass 9-19
Bypass Timers
Photo Eye 9-32
Safe Edge 9-31
C
Cabinet Installation 2-8
Calibrate Floor offsets 4-28
Calibrate Motor Field (System 12) 2-53
Call Generator 9-11
Cancel car calls behind car 9-42
Cancel In-Car CFSS Mode 1 input 9-128
Cancel In-Car CFSS Mode 2 input 9-128
Cancel remaining car calls with direction reversal 9-42
Capture Input 9-128
Capture Input OFF message 6-17
Capture Input ON message 6-17
Capture message 6-17
Capture mode 9-4
Capture Mode message 6-17
Capture Mode switch, iBox control 7-12
Car at same floor bonus 10-12
Car Call Audible output 9-137
Car Call Cancel Button input 9-128
Car Call Dwell Time 9-45
Car Call Enable 1 - Front inputs 9-134
Car Call Enable 1 - Rear inputs 9-134
Car Call Enable 2 - Front inputs 9-134
Car Call Enable 2 - Rear inputs 9-134
Car call enable floor passcodes 10-54
Car Call Enable Operation 1 (2) Override input 9-128
Car call enable passenger passcodes 10-55
Car Call Registered Audible output 9-137
Car Call Restrictions - elevator security 10-51
Car Call Security 1 (2) Override outputs 9-137
Car calls 10-85
Car Calls - Front Aux COP inputs 9-133
Car Calls - Front Aux COP light outputs 9-144
Car Calls - Front Main COP inputs 9-133
Car Calls - Front Main COP light outputs 9-143
Car Calls - Rear Aux COP inputs 9-133
Car Calls - Rear Aux COP light outputs 9-144
Car Calls - Rear Main COP inputs 9-133
Car Calls - Rear Main COP light outputs 9-144
Car Calls, how to register 4-4
Car Connections, iBox 6-110, 11-8
CAR DEL DOORS CLOSED message 6-17
CAR DEL DOORS CLOSING message 6-17
CAR DEL DOORS OPEN message 6-17
CAR DEL DOORS OPENING message 6-17
CAR DEL DOORS STALLED message 6-18
CAR DEL DOORS UNKNOWN message 6-18
Car Delayed output 9-138
Car delayed timer 9-42
Car delayed with doors closed message 6-17
Car delayed with doors closing message 6-17
Car delayed with doors open message 6-17
Car delayed with doors opening message 6-17
Car delayed with doors stalled message 6-18
Car delayed with unknown door position message 6-18
Car Door Bypass message 6-18
Car Door Bypass switch, iBox control 7-12
Car fan and light timer 9-42
Car Heavy Load - Deactivated message 6-18
Car Heavy Load Activated - Hall Calls Bypassed message 6-18

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MCE iControl and is the answer not in the manual?

MCE iControl Specifications

General IconGeneral
BrandMCE
ModeliControl
CategoryController
LanguageEnglish