Cisco Small Business 200 Series

Administration
SNTP and Time Settings
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 108
2
sntp client mode
Use this command to enable Simple Network Time Protocol (SNTP) client mode
and set the mode to either broadcast or unicast. Use the no form of the command
to disable SNTP client functionality.
sntp client mode {broadcast | unicast}
no sntp client mode
Syntax Descriptions
Default
The switch is not configured as an SNTP broadcast or unicast client.
Command Modes
Global Config
Usage Guidelines
Use the command without the optional keywords broadcast or unicast to enable
the SNTP client without specifying a mode.
Related Commands
show sntp client Displays SNTP client settings.
Parameter Description
broadcast Configures the switch to obtain its time settings from
SNTP broadcast servers.
unicast Configures the switch to obtain its time settings from
SNTP unicast servers.
Command Description
sntp server Configures SNTP unicast servers.
show sntp Displays SNTP settings and status.
Command Description