Cisco Small Business 200 Series

Quality of Service
Class of Service Commands
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 378
9
Syntax Descriptions
Command Modes
Global Config
Interface Config
Related Commands
classofservice trust
This command sets the class of service trust mode of an interface. You can set the
mode to trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet
markings. You can also set the interface mode to untrusted. Use the no form of the
command to set the interface mode to the default value (trust dot1p).
NOTE Interface Config mode configuration overrides the Global Config mode
configuration for the interface.
classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted | all}
no classofservice trust
Parameter Description
ip-precedence-
value
The IP precedence value. The range is 0–7.
trafficclass The trafficclass value. The range is 1–8.
Command Description
show
classofservice ip-
precedence-
mapping
Displays the global IP precedence value mapping to
internal traffic classes or the mapping for a specific
interface.