Cisco Small Business 200 Series

IP Configuration
IP Addresses
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 393
10
The following example configures an IPv6 address.
(switch) #network ipv6 address 3ffe:1900:4545:3:200:f8ff:fe21:67cf/24
Related Commands
network ipv6 enable
Use this command to enable IPv6 operation on the management interface. Use the
no form of the command to disable it.
network ipv6 enable
no network ipv6 enable
Default
IPv6 management is enabled.
Command Modes
Privileged Exec
Related Commands
Command Description
network ipv6
gateway
Configures the IPv6 gateway (i.e., default router) on the
management interface.
show network Displays the configuration settings associated with the
switch management interface.
Command Description
network ipv6
address
Manually configures IPv6 global address.
network ipv6
gateway
Configures IPv6 gateway (i.e. default routers) on the
management interface.
network ipv6
neighbor
Adds static IPv6 neighbor entry.
show network Displays the configuration settings associated with the
switch's management interface.