Cisco Small Business 200 Series

Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 38
2
Related Commands
PoE
The following commands configure the Power-over-Ethernet functionality on the
switch.
NOTE These commands are valid only for the SF 200E-24P and SF 200E-48P switches.
lldp med transmit-tlv
Use this command to specify the optional Type Length Values (TLVs) in the LLDP
MED set transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs) on
a specific port. Use the no form of the command to exclude the specified TLV for
the specified port.
lldp med transmit-tlv [capabilities] [ex-pse] [inventory] [location] [network-policy]
no lldp med transmit-tlv [capabilities] [ex-pse] [inventory] [location] [network-
policy]
TEMP Internally measured transceiver temperature.
Voltage Internally measured supply voltage.
Current Measured TX bias current.
Output Power Measured TX output power in milliwatts.
Input Power Measured RX received power in milliwatts.
TX Fault Transmitter fault.
LOS Loss of signal.
Command Description
show cablestatus Displays the cable connection status on a selected port.