Cisco Small Business 200 Series

Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 307
7
Related Commands
set igmp mrouter
Use this command to configure the VLAN ID (vlan-id) that has the multicast router
mode enabled. Use the no form of the command to disable it.
set igmp mrouter vlan-id
no set igmp mrouter vlan-id
Syntax Descriptions
Default
IGMP mrouter is disabled on all VLANs.
Command Modes
Interface Config
Related Commands
Command Description
show
igmpsnooping
Displays IGMP Snooping information. Configured
information is displayed whether or not IGMP Snooping is
enabled.
Parameter Description
vlan-id The ID of the VLAN to configure.
Command Description
show
igmpsnooping
mrouter vlan
Displays information about static and dynamic multicast
router information on the port.
show
igmpsnooping
mrouter interface
Displays information about statically configured mrouter
ports.