Cisco Small Business 200 Series

Administration
SNTP and Time Settings
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 98
2
SNTP and Time Settings
A system clock is used to provide a network-synchronized time-stamping service
for switch software events such as message logs. You can configure the system
clock manually or configure the switch as an SNTP client that obtains the clock
from a server. This section describes the SNTP and time commands.
This section contains the following subsections:
• Clock Commands
• SNTP Commands
Clock Commands
Use the commands described in this section to view and configure clock settings
when the SNTP feature is not used.
clock date
Use this command to set the date and time manually.
clock date dd/mm/yyyy time hh:mm:ss
Syntax Descriptions
Defaults
The switch clock initiates with the following values:
• date—01/01/1970
• time—00:00:00
Command Modes
Global Config
Parameter Description
dd/mm/yyyy The current date in day:month:year format.
hh:mm:ss The time in hours:minutes:seconds format.