Cisco Small Business 200 Series

Administration
Syslog
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 138
2
Default
maxtime—15 sec.
Command Modes
Global Config
Related Commands
logging buffered enable
Use this command to enable buffered logging (in-memory). To stop buffered
logging, use the no form of this command.
logging buffered enable
no logging buffered enable
Default
Buffered logging is enabled.
Command Modes
Global Config
Related Commands
Command Description
logging
aggregation
enable
Enables logging aggregation.
show logging Displays logging configuration information.
Command Description
clear logging
buffered
Clears the buffered log.
logging buffered
severity
Limits buffered message logging to a specified severity
level.