Cisco Small Business 200 Series

VLAN Management
VLAN
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 221
4
Command Modes
Interface Config
Related Commands
switchport general allowed vlan
Use this command to add VLANs to or remove VLANs from a general port.
switchport general allowed vlan {add vlan-list [tagged | untagged] | remove vlan-
list}
Syntax Descriptions
Default
VLANs are added as untagged VLANs.
Command Modes
Interface Config
Command Description
switchport
general allowed
vlan
Adds VLANs to or removes VLANs from a general port.
switchport
general pvid
Configures the Port VLAN ID (PVID) when the interface is in
general mode.
Parameter Description
vlan-list Specify the VLAN ID of each VLAN, separated by a space.
tagged Configures the port to admit frames tagged with this VLAN
ID and forward them with the VLAN tag. Ports are often
configured as tagged when they connect to other
switches or routers that handle VLAN-tagged traffic.
untagged Configures the port to admit frames from this VLAN and
forward them without a VLAN tag. Ports are often
configured as untagged when they connect to hosts or
peripherals that might not manage VLAN-tagged traffic.