Cisco Small Business 200 Series

Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 44
2
poe power management
Use this command to set the power management as dynamic or static. Use the no
form of the command to reset it to its default value.
poe power management {dynamic-with-priority | static- with-priority}
no poe power management
Syntax Descriptions
poe power limit Sets the method for power management.
poe priority Configures the port priority level for the delivery of power
to an attached device.
poe
usagethreshold
Configures the system power usage threshold level at
which a trap is generated and a message is logged.
show poe Displays the global configuration, and information about
each device connected to the PSE port(s).
show poe port
configuration
Displays per-port PoE configuration.
show poe port Displays per-port PoE status.
Parameter Description
dynamic-with-
priority
Power management is done by the PoE controller. Power
is supplied to devices as long as the consumption is within
the configured limit and priority. There is no pre-allocation
of power. A port with a higher port priority is given
preference when the switch supplies power to multiple
ports. If two or more port priorities are equal, the port with
the lower port number is given preference.
Command Description