Cisco Small Business 200 Series

8
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 326
Security
This chapter describes how to use the CLI to configure security features. It
includes the following topics:
• General
• RADIUS
• Dot1x
• MAC Based Port Security
General
show net connections
Use this command to display the active and open TCP/UDP services.
show net connections
Command Modes
Privileged Exec
Examples
The following shows sample output for the command.
(switch) #show net connections
Protocol type Port State Remote IP address Service n
ame
------------- ----- ----------- ---------------------------------- ---------
-
TCP 2222 Listen
UDP 0 Active
UDP 1032 Active
UDP 4567 Active
UDP 1033 Active
UDP 5353 Active