Cisco Small Business 200 Series

Security
Dot1x
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 345
8
Default
All interfaces are configured as authenticators.
Command Modes
Interface Config
Related Commands
dot1x port-control
Use this command to enable the IEEE 802.1X operation on the port. Use the no
form of the command to reset it to the default operating mode (auto).
NOTE Dot1x is not applicable to LAG ports.
dot1x port-control {force-unauthorized | force-authorized | auto}
no dot1x port-control
Syntax Descriptions
supplicant The port is configured to requests access to the network.
The supplicant provides credentials to the network that
the another node on the network—the authenticator—
uses to request authentication from a server.
Command Description
dot1x supplicant
port-control
Configures the authentication mode for supplicant on the
interface.
dot1x supplicant
user
Configures the supplicant user.
Parameter Description
Parameter Description
force-
unauthorized
The authenticator PAE unconditionally sets the controlled
port to unauthorized.