Cisco Small Business 200 Series

Administration
Syslog
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 139
2
logging buffered severity
Use this command to limit buffered message logging to a specified severity level.
Use the no form of the command to set the severity level to the default value (2).
logging buffered severity severitylevel
no logging buffered severity
Syntax Descriptions
Default
severitylevel—critical (2)
Command Modes
Global Config
show logging
buffered
Displays buffered in-memory logging information and log
entries.
Parameter Description
severitylevel The level of the traps to be logged. Traps of this level and
lower (numerically) are logged. You can specify an integer
from 0 to 7 or one of the following keywords:
• emergency (0)
• alert (1)
• critical (2)
• error (3)
• warning (4)
• notice (5)
• info (6)
• debug (7)
Command Description