Cisco Small Business 200 Series

Spanning Tree Protocol
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 263
5
spanning-tree configuration revision
Use this command to set the MST Configuration Identifier Revision Level, which
identifies the configuration that the switch is currently using. Use the no form of the
command to reset it to the default value.
NOTE This configuration is applicable only when spanning tree mode is MSTP.
spanning-tree configuration revision 0-65535
no spanning-tree configuration revision
Syntax Descriptions
Default
revision—0
Command Modes
Global Config
Related Commands
show spanning-
tree mst
summary
Displays summary information about all multiple spanning
tree instances in the switch.
Command Description
Parameter Description
0–65535 A number in the range of 0 to 65535.
Command Description
spanning-tree Enables the operation mode of spanning tree.
spanning-tree
configuration
name
Sets the MST Configuration Identifier Name, which
identifies the configuration that the switch is currently using.
show spanning-
tree
Displays spanning tree settings for the common and internal
spanning tree.