Cisco Small Business 200 Series

Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 318
7
Default
expiration time—0 (no time-out)
Command Modes
VLAN Config
Related Commands
set mld mrouter
Use this command to configure the VLAN ID (vlan-id) that has the multicast router
mode enabled. Use the no form of the command to disable it.
set mld mrouter vlan-id
no set mld mrouter vlan-id
Syntax Descriptions
Default
MLD mrouter is disabled by default on all VLANs.
Command Modes
Interface Config
0–3600 The multicast router present expiration time. The range is
0–3600 seconds. A value of 0 indicates an infinite time-out;
i.e. no expiration.
Command Description
show
mldsnooping
Displays MLD Snooping information.
Parameter Description
vlan-id The ID of the VLAN to configure.
Parameter Description