Cisco Small Business 200 Series

Quality of Service
Class of Service Commands
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 376
9
Class of Service Commands
This section describes the commands you use to configure and view Class of
Service (CoS) settings for the switch. The commands in this section allow you to
control the priority and transmission rate of traffic.
classofservice dot1p-mapping
This command maps an 802.1p priority to an internal traffic class for an interface
(in Interface Config mode) or for all interfaces (in Global Config Mode). Use the no
form of this command to reset an 802.1p priority to its default internal traffic class
value for an interface or all interfaces.
classofservice dot1p-mapping dot1ppriority trafficclass
no classofservice dot1p-mapping
Syntax Descriptions
Command Modes
Global Config
Interface Config
Related Commands
Parameter Description
dot1ppriority The 802.1p priority value. The range is 0–7.
trafficclass The trafficclass value. The range is 1–8.
Command Description
show
classofservice
dot1p-mapping
Displays the global Dot1p (IEEE 802.1p) priority mapping to
internal traffic classes or the mappings for a specific
interface.