Cisco Small Business 200 Series

Administration
Cable Diagnostics
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 35
2
Examples
The following example shows the output of this command when no VLAN is
specified.
(Switch) #show monitor session 1
Port Mirroring is enabled on Following VLAN: None
Session ID Admin Mode Probe Port Mirrored Port Type
---------- ----------- ----------- -------------- -------
1 Enable e1 e2 Rx,Tx
e3 Rx,Tx
The following example shows the output of this command when a VLAN is
specified.
(Switch) #show monitor session 2
Port Mirroring is enabled on Following VLAN: 10
Session ID Admin Mode Probe Port Mirrored Port Type
---------- ---------- ---------- ------------- -------
1 Enable e4 e5 Rx
Related Commands
Cable Diagnostics
The commands in this section enable you to run hardware diagnostic tests on
ports and view the results.
show cablestatus
Use this command to display the cable connection status on a selected port.
show cablestatus interface
Command Description
monitor session Adds a mirrored port (source port) or probe port
(destination port) to a mirroring session and enables the
administrative mode of the session.