Cisco Small Business 200 Series

Administration
Switch Management Access Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 87
2
Related Commands
serial baudrate
Use this command to specify the communication rate of the console port. The
supported rates are 9600, 38400, and 115200. Use the no form of the command to
reset it to the default value.
serial baudrate {9600 | 38400 | 115200}
no serial baudrate
Default
baud rate—115200
Command Modes
Line (Console) Config Mode
Related Commands
Command Description
serial baudrate Specifies the communication rate of the console port.
serial databits Specifies the number of data bits per character for the
console connection.
serial parity Sets the parity for the console connection.
serial stopbits Sets the number of stop bits for the console connection.
show serial Displays serial port communication settings.
Command Description
serial databits Specifies the number of data bits per character for the
console connection.
serial parity Sets the parity for the console connection.
serial stopbits Sets the number of stop bits for the console connection.
show serial Displays serial port communication settings.