Cisco Small Business 200 Series

Administration
Switch Management Access Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 76
2
Examples
The following shows sample output for the command.
(Switch) #show ip http
HTTP Mode (Unsecure)................................. Enabled
HTTP Server Port......................................... 80
Maximum Allowable HTTP Sessions................ 5
HTTP Session Soft Timeout........................... 10 minutes
Related Commands
Telnet Access
The following commands configure user access to the management interface and
outbound connections through Telnet.
ip telnet server enable
Use this command to enable the Telnet Server Admin Mode, in which the telnet
command can be used to establish a telnet connection to a remote host.
Use the no form of command to disable the Telnet Server Admin Mode and close
any existing telnet connections to remote hosts.
ip telnet server enable
no ip telnet server enable
Default
Telnet Server Admin Mode is disabled.
Command Modes
Privileged Exec
Command Description
ip http server Enables the switch to be configured, monitored, or
modified from a browser.
ip http session
soft-timeout
Configures the soft timeout for HTTP sessions.