Cisco Small Business 200 Series

Administration
SNTP and Time Settings
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 109
2
sntp client port
Use this command to configure the logical port number that the switch uses as an
SNTP client. Use the no form of the command to reset the SNTP client port to the
default value.
sntp client port port-id
no sntp client port
Syntax Descriptions
Default
port-id—123
Command Modes
Global Config
Related Commands
show sntp client Displays SNTP client settings.
show sntp server Displays settings for configured SNTP unicast servers.
Parameter Description
port-id The logical port ID.
Command Description
sntp client mode Displays SNTP client settings.
show sntp client Displays SNTP client settings.
Command Description