Cisco Small Business 200 Series

Administration
RMON
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 159
2
rmon event
Use this command in Global Config mode to configure an event. To remove an
event, use the no form of this command.
rmon event index type [community text] [description text] [owner name]
no rmon event index
Syntax Descriptions
Command Modes
Global Config
Parameter Description
index The event index. The range is 1–300.
type The type of notification that the device generates about
this event. The index type can be one of the following
values:
• none
• log
• trap
• log-trap
In the case of log, an entry is made in the log table for each
event. In the case of trap, an SNMP trap is sent to one or
more management stations.
community text If an SNMP trap is to be sent, it is sent to the SNMP
community specified by this octet string. The range is 0–
127 characters.
description text A comment describing this event. The range is 0–127
characters.
owner name Enter a name that specifies who configured this event. If
unspecified, the name is an empty string.