Cisco Small Business 200 Series

Administration
Control Packet Handling
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 24
2
Syntax Descriptions
Default
LLDP and 802.1X packets are terminated.
Command Modes
Global Config
Usage Guidelines
LLDP or 802.1X must be disabled globally before you can use this command to
configure the drop, forward, or terminate action for each protocol.
Related Commands
show protocol
Use this command to display the drop, forward, or terminate state for the CPD,
LLDP, and Dot1X protocols.
show protocol
Parameter Description
lldp Specifies that the command applies to LLDP packets.
dot1x Specifies that the command applies to IEEE 802.1X
packets.
drop Drop all packets of the specified type.
forward Forwards all packets of the specified type to the VLAN.
terminate Process the packets.
Command Description
[no] lldp med Enables and disables LLDP MED.
[no] dot1x port-
control
Enables and disables the 802.1X operation on all ports.
show protocol Displays the drop, forward, or terminate state for the CPD,
LLDP, and Dot1X protocols.