Cisco Small Business 200 Series

IP Configuration
IP Addresses
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 403
10
Examples
The following shows sample output for the command.
(switch) #show network
Interface Status............................... Always Up
IP Address..................................... 10.131.11.166
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.131.11.1
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ fe80::2ab:cdff:fe14:2e4e/64
Burned In MAC Address.......................... 00:AB:CD:14:2E:4E
Configured IPv4 Protocol....................... DHCP
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 1
Related Commands
show network ipv6 dhcp statistics
Use this command to display the statistics of the DHCPv6 client running on the
network management interface.
show network ipv6 dhcp statistics
Command Modes
Privileged Exec
Examples
The following shows sample output for the command.
(switch) #show network ipv6 dhcp statistics
DHCPv6 Client Statistics
-------------------------
DHCPv6 Advertisement Packets Received.................... 1
DHCPv6 Reply Packets Received............................ 1
Received DHCPv6 Advertisement Packets Discarded.......... 0
Command Description
network parms Sets the IP address, subnet mask and gateway of the
device.
show network
ndp
Displays the NDP cache information for the management
interface.