Cisco Small Business 200 Series

Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 305
7
Related Commands
set igmp maxresponse
Use this command to set the IGMP Maximum Response time on a particular VLAN.
The Maximum Response time is the amount of time in seconds that a switch waits
after sending a query on an interface before deleting a particular group on that
interface. Use the no form of the command to reset it to the default value. This
configured value used when querier is enabled.
set igmp maxresponse vlan-id 1-25
no set igmp maxresponse vlan-id
Syntax Descriptions
Default
maximum response time—10 seconds
Command Modes
VLAN Config
Command Description
show
igmpsnooping
Displays IGMP Snooping information. Configured
information is displayed whether or not IGMP Snooping is
enabled.
Parameter Description
vlan-id The ID of the VLAN to configure.
1–25 This value must be less than the IGMP Query Interval time
value. The range is 1 to 25 seconds.