Cisco Small Business 200 Series

Quality of Service
Class of Service Commands
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 387
9
Related Commands
show interfaces cos-queue
Use this command to display the global class-of-service queue configuration or
the configured for a specified interface.
show interfaces cos-queue [interface]
Syntax Descriptions
Command Modes
Privileged Exec
Examples
The following example shows output from the command when no interface is
specified.
(switch) #show interfaces cos-queue
Global Configuration
Interface Shaping Rate......................... 0
Queue Id Min. Bandwidth Scheduler Type
Non-IP Traffic
Class
The traffic class used for non-IP traffic. This is only
displayed when the COS trust mode is set to trust IP
Precedence or IP DSCP (on platforms that support IP
DSCP).
Untrusted
Traffic Class
The traffic class used for all untrusted traffic. This is only
displayed when the COS trust mode is set to 'untrusted'.
Command Description
classofservice
trust
Sets the class of service trust mode of an interface.
Parameter Description
interface The port number.