Cisco Small Business 200 Series

Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 322
7
Fast Leave Mode................................ Disabled
Group Membership Interval (secs)............... 260
Max Response Time (secs)....................... 10
Multicast Router Expiry Time (secs)............ 0
Related Commands
VLAN ID The VLAN ID.
MLD Snooping
Admin Mode
Indicates whether MLD Snooping is active on the VLAN.
Fast Leave
Mode
Indicates whether MLD Snooping Fast-leave is active on the
VLAN.
Group
Membership
Interval
The amount of time in seconds that a switch will wait for a
report from a particular group on a specific interface, which
is participating in the VLAN, before deleting the interface
from the entry. This value might be configured.
Maximum
Response Time
The amount of time the switch waits after it sends a query
on an interface, participating in the VLAN, because it did not
receive a report for a particular group on that interface. This
value might be configured.
Multicast
Router Expiry
Time
The amount of time to wait before removing an interface
that is participating in the VLAN from the list of interfaces
with multicast routers attached. The interface is removed if
a query is not received. This value might be configured.
Command Description
set mld Enables MLD Snooping on a particular VLAN and enables
MLD Snooping on all interfaces participating in a VLAN.
set mld fast-leave Enables MLD Snooping fast-leave admin mode on a
selected interface or VLAN.
set mld
groupmembershi
p-interval
Sets the MLD Group Membership Interval time on a VLAN.
set mld
maxresponse
Sets the IGMP Maximum Response time on a particular
VLAN.