Cisco Small Business 200 Series

Port Management
Link Aggregation
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 208
3
port-channel static
This command enables static mode on a LAG interface. By default the static mode
for a new LAG is disabled; the LAG is dynamic. However, if the maximum number
of allowable dynamic LAGs are already present in the system, static mode for a
new LAG is enabled. You can only use this command on LAG interfaces. Use the
no form of command to set the static mode on a particular LAG interface to the
default value.
port-channel static
no port-channel static
Default
Ports are not configured as members of any static LAGs.
Command Modes
Interface Config
Related Commands
show lacp actor
Use this command to display attributes for ports that are serving as a LAG actor;
that is, they actively send LACPDUs to other potential LAG members to
dynamically form a LAG.
show lacp actor {interface | all}
Syntax Descriptions
Command Description
port-channel
adminmode
Enables a LAG.
show port-
channel brief
Displays the static capability of all LAG interfaces on the
device and a summary of individual LAG interfaces.
Parameter Description
interface Shows LACP actor attributes for the specified interface.