Cisco Small Business 200 Series

SNMP
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 420
11
show snmp
This command displays SNMP client and community details.
show snmp
Command Modes
Privileged EXEC
Examples
The following shows sample output for the command.
(Switch) #show snmp
SNMP server disabled
Community-String Community-Access IP Address
-------------------- ---------------- ----------------
community1 Read/Write 10.131.11.12
Traps are enabled.
Version 1,2 notifications
Target Address Type Community Version UDP TO Retries
Port Sec
---------------- ------- -------------- ------- ------ --- -----
Version 3 notifications
Target Address Type Username Security UDP TO Retries
Level Port Sec
-------------- ------- ----------------- ------- ------ --- -----
192.168.100.55 Trap admin NoAuth-N 162 15 3
=====================================================================================
snmp-server engineID local
Use this command to specify the Simple Network Management Protocol (SNMP)
engine ID on the switch. Use the no form of this command to reset the engine ID to
a default value that is created automatically from the switch MAC address.
snmp-server engineID local engineid-string
no snmp-server engineID local
show snmp
details
Displays the SNMP client and community details.
Command Description