Cisco Small Business 200 Series

Port Management
Flow Control and Storm Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 189
3
Default
Broadcast storm control is disabled.
Command Modes
Global Config
Interface Config
Related Commands
storm-control broadcast level
This command enables and configures the broadcast storm recovery threshold for
an interface or on all interfaces as percent of port speed. If broadcast storm
recovery is active and the rate of Layer 2 broadcast traffic ingressing on an
interface exceeds the configured threshold, the traffic is dropped, limiting the rate
of broadcast traffic. In Global Config mode, the same percentage is set on all
ports.
Use the no form of command to reset it to the default value.
storm-control broadcast level 0-100
no storm-control broadcast level
Syntax Descriptions
Command Description
storm-control
broadcast level
Configures the broadcast storm recovery threshold for an
interface or all interfaces.
storm-control
broadcast rate
Configures the broadcast storm recovery threshold for an
interface or all interfaces.
show storm-
control
Shows storm control configuration on a port or on all ports.
Parameter Description
0–100 The percentage of port speed, above which traffic is
dropped.