Cisco Small Business 200 Series User Manual

Security
RADIUS
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 327
8
UDP 5353 Active
TCP 80 Listen HTTP
UDP 0 Active
TCP 23 Listen Telnet
TCP 23 Established 10.12.17.82:2692 Telnet
UDP 546 Active
TCP 0 Disabled SSH
RADIUS
This section describes how to configure RADIUS client functionality and RADIUS
servers on the switch. RADIUS functionality is primarily used for switch
management access authentication and IEEE 802.1X (“dot1X”) port access control.
radius server attribute nas-ip-addr
Use this command to configure the RADIUS client to include the NAS-IP Address
attribute in the RADIUS requests. If a specific IP address is entered, then the
RADIUS client uses that IP address in the NAS-IP-Address attribute in RADIUS
communication. If the IP address is not specified, the RADIUS client does not send
any value for this attribute.
Use the no form of the command to disable this attribute. The no form functions
the same whether or not an IP address is specified in the command.
radius server attribute nas-ip-addr[ip-address]
no radius server attribute nas-ip-addr[ip-address]
Syntax Descriptions
Command Modes
Global Config
Parameter Description
ip-address The IP address to use in the NAS-IP-Address attribute in
RADIUS communication. If the command is entered with
no specific IP address, the RADIUS client does not send
include any value for the NAS-IP-Address attribute.

Cisco Small Business 200 Series Specifications

General

Brand	Cisco
Model	Small Business 200 Series
Category	Switch
Language	English