Cisco Small Business 200 Series

Quality of Service
Class of Service Commands
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 377
9
classofservice ip-dscp-mapping
This command maps an IP DSCP value to an internal traffic class. Use the no form
of this command to map each IP DSCP value to its default internal traffic class
value.
classofservice ip-dscp-mapping ipdscp trafficclass
no classofservice ip-dscp-mapping
Syntax Descriptions
Command Modes
Global Config
Related Commands
classofservice ip-precedence-mapping
This command maps an IP-precedence value to an internal traffic class for an
interface (in Interface Config mode) or for all interfaces (in Global Config Mode).
Use the no form of this command to reset an IP precedence value its default
internal traffic class value for an interface or all interfaces.
classofservice ip-precedence-mapping ip-precedence-value trafficclass
no classofservice ip-precedence-mapping
Parameter Description
ipdscp The DSCP value, which can be specified as an integer
from 0 to 63, or symbolically through one of the following
keywords: af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5,
cs6, cs7, ef.
trafficclass The trafficclass value. The range is 1–8.
Command Description
show
classofservice ip-
dscp mapping
Displays the global IP DSCP mapping to internal traffic
classes.