3
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 173
Port Management
This chapter describes commands you use to configure switch ports and link
aggregation groups (LAGs). It contains the following sections:
• Switch Ports
• Green Ethernet
• Flow Control and Storm Control
• Link Aggregation
Switch Ports
You can use the commands described in this section to configure and view
information on switch port capabilities.
auto-negotiate
Use this command to enable auto-negotiation on a port. Use the no form of the
command to disable the auto-negotiation and put the port to fixed speed of
100 MB full-duplex.
auto-negotiate [capability1][capability2…capability5]
no auto-negotiate
Syntax Descriptions
Parameter Description
capability The capabilities to advertise. Possible values: 10h, 10f,
100h, 100f, and 1000f. If capabilities are unspecified, the
default to list of all capabilities of the port.
To Next Page
Loading...
