Cisco Small Business 200 Series

Port Management
Flow Control and Storm Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 197
3
storm-control unicast rate
This command enables and configures the unicast storm recovery rate for an
interface as packets per second. If unicast storm recovery is active and the rate of
destination lookup failure packets ingressing on an interface exceeds the
configured threshold, the traffic is dropped. In Global Config mode the same rate
is set on all ports. Use the no form of command to remove the rate threshold.
storm-control unicast rate 0-14880000
no storm-control unicast rate
Syntax Descriptions
Default
No unicast storm recovery rate is configured.
Command Modes
Interface Config
Global Config
Related Commands
storm-control
unicast rate
Configures the unicast storm recovery threshold for an
interface or all interfaces.
show storm-
control
Shows storm control configuration on a port or on all ports.
Parameter Description
0–14880000 The unicast traffic rate, in number of packets per second,
above which traffic is dropped.
Command Description
storm-control
unicast
Enables unicast storm recovery mode for an interface.
Command Description