Cisco Small Business 200 Series

Administration
System Software and Configuration Management
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 124
2
Command Modes
Global Config
Related Commands
reload
This command reboots the switch without powering it off. Reboot means that all
network connections are terminated and the boot code executes. The switch uses
the stored configuration to initialize the switch. On a reboot, the switch tries to start
with the startup configuration file. If problems are found in the startup
configuration file, then the backup configuration file is used. If the backup file also
fails, then the default configuration is applied.
When you enter this command, a prompted displays to confirm that the reboot
should proceed. The switch LEDs indicate a successful reboot.
reload
Command Modes
Privileged Exec
Related Commands
Command Description
set hostname Sets the hostname for the switch.
set contact Sets the name of a contact for the switch.
Command Description
reset factory
default
Resets the configuration to the factory defaults, and
reboots the switch.