Cisco Small Business 200 Series

SNMP
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 418
11
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet)
and there is an existing terminal interface session. Use the no form of the
command to disable it.
snmp-server enable traps multiusers
no snmp-server enable traps multiusers
Default
These traps are enabled.
Command Modes
Global Config
Related Commands
snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change
notification trap. Use the no form of the command to disable it.
snmp-server enable traps stpmode
no snmp-server enable traps stpmode
Default
These traps are enabled.
Command Modes
Global Config
Command Description
show trapflags Displays trap conditions.