Cisco Small Business 200 Series

Port Management
Switch Ports
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 178
3
Related Commands
speed all
Use this command to configure the speed of all Ethernet interfaces when not using
auto-negotiation.
speed all {100 | 10} {half-duplex | full-duplex}
Syntax Descriptions
Command Modes
Global Config
Examples
The following command sets all ports to 100 Mbps full-duplex operation when
Auto Configuration is disabled.
(Switch) (config)#speed all 100 full-duplex
Related Commands
Command Description
speed all Configures the speed of an Ethernet interface when not
using auto-negotiation.
show port Displays port information.
Parameter Description
100 | 10 Configures 100 Mbps or 10 Mbps operation.
half-duplex | full
duplex
Configures half-duplex or full-duplex port operation.
Command Description
speed Configures the speed of an Ethernet interface when not
using auto-negotiation.