Cisco Small Business 200 Series

SNMP
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 423
11
Command Modes
Global Config
Related Commands
snmp-server v3-host
Use this command to specify the recipient of Simple Network Management
Protocol Version 3 notifications. To remove the specified host, use the no form of
this command.
snmp-server v3-host {ip-address | hostname} username traps [noauth | auth |
priv
][udpport port]
no snmp-server v3-host {ip-address | hostname} traps
Syntax Descriptions
Command Description
snmp-server v3-
host
Specifies the recipient of Simple Network Management
Protocol Version 3 notifications.
Parameter Description
ip-address The IP address of the host (i.e., the targeted recipient).
Hostname The name of the host. The range is 1–158 characters.
username The user name used to generate the notification. (30
characters maximum.)
traps Indicates that SNMP traps are sent to this host.
Noauth Specifies sending of a packet without authentication.
Auth Specifies authentication of a packet without encrypting it.
Priv Specifies authentication and encryption of a packet.
port The UDP port of the host to use. The range is 1025–65535.
The default is 162.