Cisco Small Business 200 Series

Multicast
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 304
7
Related Commands
set igmp groupmembership-interval
Use this command to set the IGMP Group Membership Interval time on a VLAN.
The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a specific interface before
deleting the interface from the entry. Use the no form of the command to reset it to
the default value.
set igmp groupmembership-interval vlan-id 2-3600
no set igmp groupmembership-interval vlan-id 2-3600
Syntax Descriptions
Default
group membership interval—260 seconds
Command Modes
VLAN Config
Command Description
show
igmpsnooping
Displays IGMP Snooping information. Configured
information is displayed whether or not IGMP Snooping is
enabled.
Parameter Description
vlan-id The ID of the VLAN to configure in fast-leave mode.
Group
Membership
Interval
The interval from 2 to 3600 seconds.