Cisco Small Business 200 Series

Port Management
Green Ethernet
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 186
3
Syntax Descriptions
Default
Energy Detect mode is enabled on all interfaces.
Command Modes
Global Config
Interface Config
Usage Guidelines
When the Energy Detect is enabled, the switch automatically enters the low-
power mode when energy on the line is lost, and it resumes normal operation
when energy is detected. When the port PHY is in low-power mode, the PHY
wakes up after a certain period of time and sends link pulses to monitor for energy
from the link partner. If energy is detected while the port is in wake-up mode, the
switch returns the port to normal operation. When the wake-up period expires, the
port returns to low-power mode.
Related Commands
show green-mode
Use this command to show the green mode configuration for a gigabit Ethernet
interface or all gigabit Ethernet interfaces.
show green-mode [interface]
Parameter Description
interface The port number.
Command Description
show green-
mode
Displays green-mode configuration and operational status
for the switch.