Cisco Small Business 200 Series

Port Management
Link Aggregation
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 203
3
NOTE LACP mode is for the physical interface, when this port is configured as a member
of static LAG then this configurable does not apply and this port can become an
active member of the LAG. The LACP mode must be enabled for this port to
participate in a dynamic LAG. If this mode is off and this port belongs to a dynamic
LAG this port will fail to become an active member.
port lacpmode all
This command enables Link Aggregation Control Protocol (LACP) on all physical
ports. Use the no form of command to disable LACP on all ports.
port lacpmode all
no port lacpmode all
Command Modes
Global Config
Related Commands
port lacptimeout (Interface Config)
This command sets the timeout on a physical interface of a particular device type
(actor or partner) to either long or short timeout. Use the no form of command to
set the timeout to its default value on a physical interface of a specific device type
(actor or partner).
port-channel
adminmode
Enables a LAG.
Command Description
Command Description
port lacpmode Enables LACP on a port.
port lacptimeout
(Interface Config)
Sets the timeout on a physical interface of a particular
device type.
port lacptimeout
(Global Config)
Sets the timeout for all interfaces of a particular device
type.
port-channel
adminmode
Enables a LAG.