Cisco Small Business 200 Series

Administration
Switch Management Access Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 89
2
Related Commands
serial stopbits
Use this command to set the number of stop bits for the console connection. Use
the no form of the command to reset it to its default value (1).
serial stopbits {1 | 2}
no serial stopbits
Default
stop bits—1
Command Modes
Line (Console) Config Mode
Related Commands
Command Description
serial databits Specifies the number of data bits per character for the
console connection.
serial baudrate Specifies the communication rate of the console port.
serial stopbits Sets the number of stop bits for the console connection.
show serial Displays serial port communication settings.
Command Description
serial databits Specifies the number of data bits per character for the
console connection.
serial baudrate Specifies the communication rate of the console port.
serial parity Sets the parity for the console connection.
show serial Displays serial port communication settings.