Cisco Small Business 200 Series User Manual

Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 42
2
Related Commands
poe power limit
Use this command to set the power management method. Use the no form of the
command to reset the method to the default.
poe power limit {{dot3af | user-def 3000-16200}} | [lldp-med]}
no poe power limit
Command Description
lldp med
transmit-tlv
lldp med
transmit-tlv all
Specifies the TLVs in the LLDP MED set transmitted in the
Link Layer Discovery Protocol Data Units (LLDPDUs) on a
specific port or on all ports.
poe power
management
Sets the power management as dynamic or static.
poe power limit Sets the method for power management.
poe priority Configures the port priority level for the delivery of power
to an attached device.
poe
usagethreshold
Configures the system power usage threshold level at
which a trap is generated and a message is logged.
poe reset Configures the PoE functionality to reinitialize
automatically on encountering a fault condition.
poe powered-
device describe
Adds a comment or description of the powered device
type to enable the operator to remember what is attached
to the interface.
show poe Displays the global configuration, and information about
each device connected to the PSE port(s).
show poe port
configuration
Displays per-port PoE configuration.
show poe port Displays per-port PoE status.

Cisco Small Business 200 Series Specifications

General

Brand	Cisco
Model	Small Business 200 Series
Category	Switch
Language	English