Cisco Small Business 200 Series

Spanning Tree Protocol
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 267
5
spanning-tree mode
Use this command to configure the spanning tree protocol. To return to the default
configuration, use the no form of this command.
spanning tree mode {stp | rstp | mstp}
no spanning tree mode
Syntax Descriptions
Default
Rapid Spanning Tree Protocol (RSTP) is enabled.
Command Modes
Global Config
Related Commands
spanning-tree mst
Use this command to set the Path Cost or Port Priority for the specified port within
the multiple spanning tree instances or in the common and internal spanning tree.
Use the no form of this command to reset these values to their defaults.
spanning-tree mst mstid {{cost 1-200000000 | auto} | {external-cost 1- 200000000 |
auto} | port-priority 0-240}
Parameter Description
stp Configures common Spanning Tree mode.
rstp Configures Rapid Spanning Tree mode.
mstp Configures Multiple Spanning Tree mode.
Command Description
show spanning-
tree
Displays spanning tree settings for the common and internal
spanning tree.
show spanning-
tree brief
Displays spanning tree settings for the bridge.