Cisco Small Business 200 Series

Administration
Switch Management Access Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 77
2
Related Commands
telnet
Use this command to establish a new outbound Telnet connection to a remote
host.
telnet {ip-address | hostname} port [debug] [line] [localecho]
Syntax Descriptions
Defaults
• No ip address or hostname.
• Port—23
Command Description
telnet Establishes a new outbound Telnet connection to a remote
host.
show network Displays configuration settings associated with the
switch's management interface.
show telnetcon Displays Telnet configuration and status information.
Parameter Description
ip address The IP address of the Telnet server.
hostname The hostname of the Telnet server. Ensure that a DNS
server is configured if a hostname is specified.
port The logical port number for Telnet communications in the
range of 1025 to 65535.
debug
Displays the currently enabled Telnet options.
line
Sets the outbound Telnet operational mode as line mode.
By default, the operational mode is character mode.
localecho
Enables keystrokes entered on the local device to be
echoed back to the screen immediately.