Cisco Small Business 200 Series

Quality of Service
Class of Service Commands
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 383
9
Related Commands
show classofservice dot1p-mapping
Use this command to display the global Dot1p (802.1p) priority mapping to internal
traffic classes or the mappings for a specific interface.
show classofservice dot1p-mapping [interface]
Syntax Descriptions
Command Modes
Privileged Exec
Examples
The following command displays the global 802.1p mapping:
(switch) #show classofservice dot1p-mapping
User Priority Traffic Class
------------- -------------
03
11
22
34
45
56
Command Description
cos-queue min-
bandwidth
Specifies the minimum transmission bandwidth guarantee
for each interface queue.
cos-queue wrr Activates the weighted scheduler mode for each specified
queue.
show interfaces
cos-queue
Displays the class-of-service queue configuration for the
specified interface.
Parameter Description
interface The port number. If specified, the Dot1p mapping table of
the interface is displayed. If omitted, the most recent
global configuration settings are displayed.