Cisco Small Business 200 Series

Administration
PoE
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 52
2
e4 Enable low 15.400 class alt-a 4ptdot3af
e5 Enable low 15.400 class alt-a 4ptdot3af
e6 Enable low 15.400 class alt-a 4ptdot3af
e13 Enable low 15.400 class alt-a 4ptdot3af
e14 Enable low 15.400 class alt-a 4ptdot3af
e15 Enable low 15.400 class alt-a 4ptdot3af
e16 Enable low 15.400 class alt-a 4ptdot3af
e17 Enable low 15.400 class alt-a 4ptdot3af
e18 Enable low 15.400 class alt-a 4ptdot3af
The following shows sample output for a specific port.
(switch1) #show poe port configuration e1
Interface...................................... e1
Description....................................
Admin Mode..................................... Enable
Priority....................................... low
Power Limit(W)................................. 15.400
Power Limit Type............................... class
Port Pair...................................... alt-a
Detection Type................................. 4ptdot3af
Related Commands
show poe port info
Use this command to display PoE status for a port or all ports.
show poe port info {all | interface}
Command Description
show poe Displays the global configuration, and information about
each device connected to the PSE port(s).
show poe port
info
Displays PoE status for a port or all ports.
show poe port
statistics
Displays PoE statistics for a port or all ports.