Cisco Small Business 200 Series

IP Configuration
IP Addresses
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 395
10
Syntax Descriptions
Command Modes
Privileged Exec
Related Commands
network parms
Use this command to set the IPv4 address, subnet mask, and gateway for the
switch. The IP address and the gateway must be in the same subnet.
network parms ip-address netmask [gateway]
Syntax Descriptions
Defaults
• Default IP address: 192.168.1.254
• Default mask: 255.255.255.0
• Default gateway: 192.168.1.1
Parameter Description
ipv6-address The neighbor’s global IPv6 address.
mac-address The neighbor’s MAC address.
Command Description
show network
ndp
Displays system network IPv6 neighbor entries.
Parameter Description
ip-address The IPv4 address.
netmask The network mask.
gateway The default gateway IP address.